Box & Papers:
-
Feed section
Feed section
Description:
- The machine is equipped with an alarm bell, and during movement the bell rings continuously, ensuring the safety of workers.
- The drive shaft is equipped with a friction clutch, which prevents accidental activation and damage to the machine.
- Pneumatic blocking device.
- Frequency drive as the main one, frequency conversion control system, energy saving, stable start and engine start protection device.
-
Roller feed system on the leading edge
Roller feed system on the leading edge
Description:
- Vacuum auxiliary supply system, 7,5 kW fan, air volume adjustment to ensure smooth supply.
- The cutting section is equipped with a chain switch for the possibility of an emergency stop of the feed.
- Roller feed system along the leading edge.
- Positioning of the side and rear reflector are regulated electrically; the gap on the front reflector is adjusted manually.
- The system of filing with separate sheets (if necessary, you can choose continuous or sheet-by-sheet filing).
-
Mechanical part
Mechanical part
Description:
- All shafts are chrome-plated and polished.
- All gears undergo heat treatment and are made of high-quality 45# carbon steel produced by Shansa Datong Armaments Department. The gearbox uses a keyless compensating seam to reduce center wear and accurate alignment. Transmission structure - without backlash.
- Automatic lubrication system. Oil tanks are made of thick iron plates, which excludes oil leakage.
- All bearings are from the Chinese national manufacturer of high-quality products - Harbin Bearing.
- The walls of the machine undergo heat treatment and are made of malleable cast iron. Thickness: 40 mm, they have good damping properties and do not deform.
-
Electrical part
Electrical part
Description:
- All electrical equipment is from the well-known Chinese manufacturer Zhejiang Zhengtai Electric Appliance.
- The main drive engine is from Hebei Hengshui. Stepless speed regulation, stable operation in energy saving mode and operation at low speed.
- When starting, a signal bell is sounded, ensuring the safety of the operator.
-
High-speed rotary cutting line, GM series
High-speed rotary cutting line, GM series
Main characteristics:
- Max. sheet size: 1200 × 1600 mm
- Max. die size: 1200 × 1500 mm
- Max. speed: 120 blanks/min.
- Cardboard thickness: 4-10 mm
- Min. die-cut size: 350 × 600 mm
- Deviation during feeding: ± 1mm
- Internal width: 1900 mm
- Power of the main drive: 7,5 kW
- Wall panel thickness: 50 mm
To order this equipment, contact info@epikurgroup.com